Exoair 220 - 5 Gallon Pail

About this product

ExoAir 220 is intended to secure buildings against airflow and leakage while enabling vapour materials to diffuse through and not become entombed within the wall Condensation occurs within the wall cavity as a result of entombed humidity vapour, which can result in extensive degradation and truncated structure life. ExoAir Wind Barrier Systems also include ExoAir Liquid Wind & Insulating Properties Membrane for roller and dab implementation, the ExoAir Self-Sealant Wind & Moisture Barrier Ultrafiltration, the ExoAir TWF Self-Adhered Thru-Wall Flashing Outer layer, ExoAir Dismissal Latex caulk, and litigation application. With the incorporation of ExoAir 220 into the ExoAir Wind Barrier Systems, a testing ground for effectiveness, reliability, and ease of application has been established. A comprehensive, interoperable wind and vapour barrier system from a particular source with confidence. The US Environmental protection Agency forecasts that a comprehensive, efficient structure in order, energy efficiency can be enhanced by up to 40 percent of the overall while also continuing to improve comfort conditions. EXOAIR 220 is a seamless, monolithic membrane that creates a fully, adhered air barrier when properly installed. The ability to roller or spray apply the material affords the contractor the, ability to accelerate installation times compared to traditional selfadhered, membrane systems., The high-performance properties of the EXOAIR 220 membrane retard, the migration of air and bulk water but allow water vapor to pass, through the membrane. As a result, vapor permeable systems like, EXOAIR 220 allow for more flexibility in the placement of the air barrier, membrane in the wall design. Type - Polymer-Modified emulsion Color - Black Solids - 60% Density - 8.7 lb/gal Applicable via Spray/Roller Thickness - Minimum 60 mils (wet), 36 mils (dry) to represent actual dry film thickness Storage Temperature - 40 to 100 ?F (5 to 37 ?C) Cure Time - 16 to 24 hr at 75 ?F (24 ?C), 50% RH Apply at a temperature - Above 40 ?F (5 ?C) and rising. If installing below 40 ?F (5 ?C), please refer to Cold Weather Air Barrier Installation Technical Bulletin or contact Tremco Technical Service at 866-209-2404 Service Temperature - Intermittent Exposure up to 158 ?F (70 ?C) Maximum V.O.C. - Method 310, 2 g/L Crack Bridging - ASTM C1305, Pass Elongation Tensile Strength - ASTM D412, Die C 900%, 325 psi Pliability, 180?, 1"" (25 mm) mandrel @ -29 ?F (-34 ?C) (Low Temperature Flex) Nail Sealability ASTM D1970 _ Section 7.6, Pass, ASTM D1970 _ Section 7.9, Pass Adhesion - ASTM D4541, Concrete: 28 psi, Exterior Sheathing: 19 psi Water Penetration - ASTM E331, Passed at 12 lb/ft_ (575 Pa) Air Leakage of material - ASTM E2178; Free Film Method @ 75 Pa 0.0001 cfm/ft_ (0.0006 L/(s?m_)) Air Leakage of assembly - ASTM E2357, 0.002 cfm/ft_ @ 1.56 lb/ft_ (0.012 L/(s?m_) @ (75 Pa)) Water Vapor Transmission - ASTM E96, Wet Cup 13 US Perms.