Dampseal 101 Epoxy Sealer - 1 Gallon Kit

About this product

Dampseal 101 is a deep penetrating, low-viscosity, 100% solids, two-component epoxy sealer designed to provide excellent adhesion to suitably prepared concrete substrates. Sealers containing solvents (or water) fill the voids in the concrete initially, but upon evaporation of the solvent (or water) these sealers leave voids only partially filled. Filling these voids, Dampseal 101 forms a barrier to diminish out gassing, a cause of blistering and delamination of subsequent coatings or coverings. Dampseal 101 also strengthens the concrete by penetrating into its surface. Advantages: Low viscosity for maximum penetration and 100% solids to fill voids completely Outstanding adhesion on damp substrates such as dew covered or damp concrete The capability to seal recently cast concrete provided the surface is treated to eliminate laitance and release agents Uses: Dampseal 101 provides a sealer that performs under adverse weather conditions on suitably prepared substrates. Even when applied to damp substrates such as dew coated concrete, Dampseal 101 has outstanding adhesion. Its low sensitivity to humidity makes Dampseal 101 especially suitable for sealing concrete. Dampseal 101 can be applied on concrete within one week of casting, as long as the surface is free of laitance. Application: For Best Results, Dampseal 101 Should Be Applied Towards The End Of The Day, When The Concrete Is In The Cooling Phase. Apply Dampseal 101 with a 1/2" roller in two applications. Apply the first coat at a rate of 200 sq.ft./gal. to completely fill the pores. Immediately after applying, using the same roller with no additional material, redistribute the first coat to refill any depressions formed by absorbed material. Broadcast sand over the wet Dampseal101, completely covering the surface. Allow to cure a minimum of 1-2 hours. Once dry, brush or blow excess sand off the surface and apply a second coat of Dampseal 101 at approximately 200 sq.ft./gal. It is recommended that all concrete be tested for moisture content prior to application of Sealoflex Products. Structural concrete moisture should be