ReflectiClean Elastomeric Coating - 5 Gallon Pail

About this product

ER Systems ReflectiClean is a single component, water borne, corrosion resistant, elastomeric coating. It is the only elastomeric roof coating that provides tenacious adhesion to Kynar- and Hylar- coated metal. ReflectiClean is water borne and has low VOCs, making it safe for the environment and easy to apply. Application: Application may be by brush, roller or airless spray. Brush or Roller: Recommended for flashing, small inaccessible areas or where over spray may be a problem. Use a paint brush or a standard medium or coarse nap roller. Surface preparation: Ferrous substrates must be prepared properly for maximum corrosion protection and long service life. All loose rust must be removed by power washing, wire brushing or sand blasting. Kynar- and Hylar-coated metal, New galvanized or galvalume steel must be cleaned to remove any rolling oils or grease before application of ReflectiClean. Airless Spray Equipment: Airless spray equipment should be capable of 1 gallon per minute capacity at 3000 psi. ReflectiClean is designated a "medium elastomeric coating" with medium viscosity for pump purposes. 1/2" high pressure hoses perform well. The airless spray gun should be equipped with a ball-bearing swivel for ease of handling. Recommended orifice size is .015 - .019" diameter, wide-angle fan pattern. A reverse-a-clean nozzle is recommended. Exact orifice size will vary with temperature of the material and weather conditions. Existing coatings must be tested to determine compatibility and intercoat adhesion. Apply a test area of 6 - 12 sq. inches of ReflectiClean embed polyester leaving a fabric tail exposed and allow to cure. A 90° pull on the fabric tail will provide an indication of adhesion.